Foppapedretti SKILL i-Size, Руководство по сборке

Страница: 27 / 100

• ENGLISH •
27
3. Line up the Smart Fix connectors with the FIX guides. Attach the two Smart Fix
connectors to the two anchorages points on the vehicle seat respectively. You will hear
two sounds of “clicks”. And check the FIX indicator on each side turns to green (5E).
4. Pull the handle, at the same time push the car seat as far back as possible (5F). Make
sure the back of child seat is against the backrest of vehicle seat firmly.
6. UNFASTENING YOUR CHILD SEAT
To unfastening your child seat, please press the button “1” and simultaneously pull the
FIX release button “2”. The ISOFIX indicator will turn red. Repeat this process on both
ISOFIX release buttons.
7. INSTALLATION WITH 3-POINT SAFETY BELT
1. Check that both FIX connectors are in the original position (innermost). If not, press
and hold the FIX adjustment lever and simultaneously push the FIX connector arms
back into the base of the car seat (7A).
2. Position the car seat on the vehicle seat, checking that the car seat backrest is
aligned with that of the vehicle seat. Note: remove or rotate the seat headrest if it
obstructs this process (7B).
3. Follow the directions in paragraph “8. Securing your child” to complete installation.
8. SECURING YOUR CHILD
Before securing your child in the child seat, please make sure the headrest is adjusted
to the correct position (see section 2, 8A).
Check your vehicle’s manual to see if your vehicle is equipped with ISOFIX lower
anchorages; choose one method of installation in the vehicle, either section 5 o 7 was
followed correctly.
1. Have your child sit down in the child seat.
2. Regulate the width of the side wings, if necessary.
3. Pull out the safety belt and guide it to in front of your child to the seat buckle. Buckle
it up with an audible “click” (8B).
4. Guide the lap belt and one end of diagonal belt to the belt guides under the both
armrests (8C).
5. Insert the diagonal portion of the chest belt into the guide under the headrest (8D).
6. Remove all the slackness of safety belts to the retractor (8E). Pull the diagonal part of
the car belt upwards, so that the entire belt is taut and snug against the child’s chest
and legs, without tightening the belt excessively.
7. To remove the child from the car seat, simply unclasp the seat belt buckle,
accompanying the belt as it rolls up.
Checklist before you go:
• The diagonal belt must run over in the middle of your child’s shoulder, not in his or
her neck (8A).
• The chest belt must pass through the guide placed under the headrest (8D).
• The headrest must be positioned so that there is a gap of two fingers between it and
the child’s shoulders (8A).
• The lap belt must lie as low as possible on your child’s pelvis on both sides (8A).
USE IN THE VEHICLE