MAIN MODE + MONITOR
- In the switcher’s MAIN/MONITOR position, the mix of the signal of the bus MAIN is routed to an amplifier
channel and another amplifier channel the bus signal MONITOR.
- Connect the loudspeaker monitor to the loudspeaker connector MONITOR and the main loudspeaker to
the loudspeaker connector MAIN in the rear panel of the
SMA-208RUB
.
- The output signal MONITOR is controlled using the MONITOR control on the front panel of the device,
while the output signal MAIN is adjusted with the control MAIN on the front panel of the device.
Note
: respect the instructions concerning the resulting impedance of the loudspeaker connection .
BRIDGE MODE (BRIDGE)
- Using the bridge mode (BRIDGE MODE position on the routing switcher) the two amplifier channels
internally connect to each other so that the sum of their power in one output corresponds to the mix of
the bus MAIN. In this case the charge impedance must be of 8 Ω.
- Connect the loudspeaker to the loudspeaker connector BRIDGED on the rear panel of the
SMA-208RUB
.
- The volume of the output signal is adjusted with the control MAIN on the front of the device.
Note
: respect the instructions concerning the resulting impedance of the loudspeaker connection .
- 9 -
EN
160205_SMA-208RUB_MANUAL_(EN)_Maquetación 1 5/2/16 13:53 Página 9
