4
RaPId oPeRaTInG InSTRuCTIonS
The following instructions will help you to switch the boiler on quickly and regulate it for immediate use.
It is presumed that the boiler has been installed by a qualified installer, it has been commissioned and is ready to operate
correctly.
If any accessories have been fitted on the boiler, these instructions will not cover them. You will therefore have to refer to the full
boiler instructions as well as to the specific instructions for the accessories.
This manual contains full details of how the boiler works, and
full operating and safety instructions.
1. Open the gas cock installed ahead of the boiler.
2. Turn the master switch installed ahead of the boiler to ON: boiler display (fig. 1) comes on.
6. To set the DHW water temperature press DHW +/- buttons (d, fig. 1). Set temperature as required.
7. To set the heating water temperature, press heating water +/- buttons (e, fig. 1). Set temperature as required.
8. Set the desired temperature on the (optional) ambient thermostat in the building.
The boiler is now ready to operate.
If the boiler shuts down, press "reset" button (F, fig. 1).
If boiler does not resume its normal operation after 3 attempts, contact a qualified Service Centre.
3. If you do not wish to activate the heating function, press the "operating mode selection" button until
displaying the symbol : only the DHW function will be enabled.
5. If you do not wish to activate the DHW function, press the "operating mode selection" button
until displaying
the symbol : only the CH function will be enabled.
4. If you wish to activate both the heating and DHW functions, press the "operating mode selection" button
until displaying the symbol .
