6
Specifications
Electrical
Each icemaker and dispenser requires separate circuit. Equipment
ground required.
Standard electrical – 230V, 50 Hz, 1 phase, Max. fuse – 5 amps,
15 amp circuit. Cord provided.
Plumbing
Drain 1" PVC FPT for hopper drain
Note: Drains should be hard piped and insulated. Maintain
at least 1cm per 31cm (1/4" per foot) run slope on
drain
line
run.
Temperature
Ambient temperature range: 10˚C (50˚F) minimum; 38˚C (100˚F)
maximum.
Clearance, installation and access information
The dispenser must be level in both directions. The dispenser is to
be installed in a location where use and maintenance is restricted to
trained personnel. The supply cord plug must be accessible.
Door entry Installation sites must have an unobstructed path to
installation location with door openings no less than
870mm (34.25").
Service clearance A minimum of 305mm (12") to left of unit is
necessary for service.
Ice type
Dispenser can accommodate most cube/cubelet ices up to 26mm
(1") square. Crushed, flake, or nugget ice cannot be used. Use of
these ices can jam dispenser and void warranty. For questions about
ice compatibility, call technical service at (610) 252-7301.
Icemaker weight limit
Icemaker(s) mounted on thin top may not exceed 272kg (600 lbs).
Icemaker(s) mounted on thick top may not exceed 590kg (1300 lbs).
Container sizes
Standard unit accommodates bag sizes up to 9kg (20 lbs)/
696mm (27.35").
Standard dispense chute compatible with carts and containers up to
750mm (29.5") high.
Optional 166mm (6.5") leg extension kit may be purchased to allow
for up to 915mm (36") high carts and bags up to 18kg (40 lbs) and
860mm (33.85") high.
Bag pins
Bag pins may be adjusted to accommodate bag hole centers from
127mm (5") to 254mm (10").
