Follett C/E25CR400A/W-S, Инструкция по установке, эксплуатации и обслуживанию

Страница: 14 / 32

14
Installing top mount icemakers
(models C/E25CT400A/W, C/E50CT400A/W, C/E25HT400A/W, C/E50HT400A/W)
1. On dispensers equipped with top mounted, water-cooled icemakers, feed condenser supply and drain lines
from back through utility knock-out (Fig. 4F) or through counter, as appropriate. Connect condenser supply
line to inlet fi tting (Fig. 3H) on utility fl ange at bottom of dispenser. Connect condenser drain line to outlet
fi tting (Fig. 3J) on utility fl ange at bottom of dispenser.
Note: Do not run condenser supply water through icemaker water fi lter system. Do not connect condenser
drain line to any other drain lines.
2. Remove dispenser top front cover by removing two screws at bottom corners of cover, lifting cover slightly
and pulling forward.
3. Remove icemaker compartment top and side panels.
4. Remove icemaker hold-down bracket from front of icemaker compartment.
5. Lift icemaker onto dispenser top and slide icemaker completely into position, compressor end fi rst. Front of
icemaker base must be fl ush with front of dispenser.
6. Reinstall hold-down bracket on front of icemaker with power cord and bin signal cords in notch. Do not cut or
pinch cords.
7. Insert loose end of ice transport tube through bracket on icemaker base into hopper access hole. Be sure that
transport tube is secured under retainer on fl oat reservoir bracket (Fig. 10, Step 2). Tighten transport tube clamp
screw to secure ice transport tube.
8. Connect plastic water supply line to fi tting at top of fl oat reservoir.
9. Connect vinyl drain from dispenser securely to 120° elbow on icemaker drain line.
10. Connect icemaker two-lead bin signal twist lock plug, and three-lead power connector, to dispenser twist-
connectors.
11. On dispensers equipped with water-cooled icemakers, connect condenser water supply and drain lines to
condenser fi ttings on icemaker.
12. Turn on water supply and check for leaks. Check that water level in fl oat reservoir (when full) is within 7mm
(1/4") of mark on side of reservoir, and that fl oat moves freely. Verify that water sensor tabs are immersed in
water in reservoir. Replace splash panel.
13. Install appropriate plug on power cord and insert into wall socket.
14. If dispenser is equipped with SensorSAFE remote protective plastic coating from dispense sensor labels.
15. Turn on power and bin signal rocker switches and test operation.
16. Clean and sanitize icemaker following instructions in icemaker manual.
17. Remove dispenser hopper access lid and clean and sanitize dispenser according to instructions on page 16.
18. Replace side and front covers and secure with screws. Installation is complete.
1
2
3
TIGHTEN
CLAMP
SCREW
Fig. 10 – Ice transport tube
Dispensers with top mount icemakers cannot be mounted on legs. They must be bolted to
counter. Use gloves when lifting icemaker to protect hands from sheet metal edges.
!