Focustronic Mastertonic, Руководство пользователя

Страница: 16 / 33

16
Action Mode
If you own one of our power sockets or a Dosetronic, you can let
these units do actions based on the measurements from
Mastertronic. If you want these interactions then set action mode
to ON, and set the reference values. Mastertronic will now interact
with Dosetronic/PowerTronic by changing an assigned channel
(see below) or open/close an assigned socket, when the values of
the parameter are outside the reference values.
Automatic Mode
After Mastertronic has performed an alteration of the assigned channel/s in
Dosetronic, its going to set back to
Action Mode OFF and will remain OFF until you
manually reactivate it. But if you also have the ” Automatic Mode ” enabled, the A ction
Mode will automatically set back to ON after 4 days after an action. This is due to
some parameters taking a few days to react to any changes made, and won’t allow
the Mastertronic to keep correcting corrections
Assign Solartronic
(Coming soon)
Here you assign the Solartronic to obey from the results of
the parameter measured by Mastertronic. Typically its the
nutrients parameter you assign to your Solartronic. The %-
change button is how much the overall light intensity shall be
changed if the assigned parameter (typical NO
3
, PO
4
) is
outside the reference values. + (plus)-Direction means that if
the parameter is above high ref value it will increase light
intensity, and if below low ref value it decreases light intensity.
- (minus) direction acts in the opposite way.
Assign sockets in PowerTronic
( Coming soon)
Here you choose which socket/s you want to obey under
the results of the parameter measured by Mastertronic.
Assign channels in Dosetronic
Needs a DT sw gen 2.5, see here.
Here you choose which channel/s in Dosetronic you
want to obey from the results of the parameter
measured by Mastertronic.
Note: In MT the alkalinity test is limited to 1 scheduled test
per day, and therefore the KH from MT will not be able to
control the DT.