Focustronic Alkatronic, Руководство пользователя

Страница: 11 / 39

11
If action mode is disabled, the socket will not react to the dKH values, but will
be left in it's last position. For safety reasons, the socket is always in ON-mode
(orange) after a power up of the machine. Remember that if you want to be
able to change the socket both manually with the toogle-button, or let the
machine do so by automatic actions, you must have ”action mode” enabled.
Prime hoses and Calibrate pumps/electrode
Prime hoses
Now you must prime the hoses from Pump A, C and D . See fig 2a.
1) Go to the main menu and select ”Prime Hose”, and begin with Pump A.
2) Press START, and make sure the water is moving upwards in the hose from the
tank water. Follow it carefully until it is delivered into the test vial and you are
sure there are no air bubbles anywhere in the hose. Press STOP.
3) Now do the same for Pump C (reagent fluid) , and Pump D (carbonate solution).
Do not worry if there is now some water/reagent in the test vial, there should be.
Calibrate Pumps
Pump A
1) Take out the pipe from Pump A, by moving the pipe forward from
the probe holder, and place it in the largest test cylinder (100 ml
cylinder).
2) In main menu, press ”Calibrate” and then select ”Pump A”.
3) Make sure the pipe is placed down in the test-cylinder, and press
Calibrate.
4) Pump A now starts, and stops automatically.
5) When it stops, take the pipe out of the cylinder, place the cylinder
on a horizontal surface, and read the water line. Make sure to read
it correctly, see Fig 3a.
Observe that in this 100 ml
cylinder every line corresponds to 1 ml.
6) Note the value in the number fields with one decimal,
then
press save . Make sure the command is taken by
looking at the LCD, where the entered value will be
shown.
If it is not shown, press save again. Now return the
pipe to its proper position in the holder, see figure 2b.
Fig 3a. Read at the red line