background image

CLEANING

ALWAYS  D

DISCONNECT/ISOLATE  TTHE  A

APPLIANCE  A

AT  TTHE  SSUPPLY/OUTLET SOCKET  A

AND ALLOW TO

COOL BEFORE U

UNDERTAKING A

ANY C

CLEANING.

Regularly clean around the appliance to ensure that dust, fluff, pet hair/dander etc, are kept to a minimum. 

There are no other specific requirements for care, other than regular cleaning of the general appliance.  A wipe

with a dry cloth is normally sufficient. 

DO NOT use abrasive cleaners as they can damage the finish. Stainless steel parts may be cleaned using an
appropriate metal cleaner or baby oil. Test on a hidden part of the stainless steel before cleaning. Clean only in
the direction of the grain. 

SERVICING

There aare nno iinternal uuser sserviceable pparts.

Check regularly for security of wall fixings as appropriate. Also check the security and condition of the supply
cable and connections. If the supply cable becomes damaged, it must be replaced by a service agent or com-
petent person, such as a qualified electrician.

Fuse R

Replacement:

Use an approved fuse to BS 1362 and proceed as follows:

1. Remove the fuse cover (A) and fuse (B). See Fig 9.
2. Fit replacement 13A fuse into fuse cover, and then refit both into plug. 

If the fuse cover (A) is missing or lost the plug must not be used until a replacement
is fitted. Replacements are available from your local electrical store

8

As our policy is one of continuous improvement and development, we hope therefore you will understand we must retain the right to amend details and/or specifi-
cations without prior notice.

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retail-
er for recycling advice

DO005970/0

14.0

13.0

The wires in the cable are coloured in accordance with the 

following code:

LIVE

- BBrown

NEUTRAL

- BBlue

EARTH

- G

Green/Yellow 

Fig 99

BBeeffoorree C

Caalllliinngg tthhee M

Maannuuffaaccttuurreerr

You will be charged for a Service Engineers visit if a problem with your appliance is caused by incorrect

installation, incorrect use, or damage caused by use of ancillary equipment not defined as suitable in this

instruction manual.

©

2007 Focal Point Fires plc.

Please N

Note :: Except where otherwise stated, all rights, including -copyright

in the text, images and layout of this booklet is owned by Focal Point Fires
plc. You are not permitted to copy or adapt any of the content without the
prior written permission of Focal Point Fires plc.

Содержание OBLIQUE ELECTRIC











Отзывы: