Controlling the LCD display
panel
Scene select buttons:
The
appliance is pre-programmed
with nine different scenes as
shown in figures 1 through 9.
These scenes have been specially
edited to run in a seamless loop.
When the appliance is switched
on, the log fire scene will auto-
matically run. To select a different
scene press the appropriate
scene select button to choose
the deisred scene. During normal
operation the footage may occasionally be seen to ‘freeze’ for a fraction of a second. This
happens as the scene is recycled to loop again. This is perfectly normal and should be no
cause for concern.
Volume up, down and mute button:
Some of the LCD scenes include sound effects.
These buttons raise and lower the volume. The Mute button mutes the speakers. While the
speakers are muted, a symbol will be displayed on screen. Press again to de-activate.
The appliance can be switched off at any time, irrespective of the particular
mode selected, by simply switching the first switch marked (OI) to the “off ”
position. It is also recommended to unplug the power supply cable at the supply
outlet when not in use.
This appliance has a safety cut-out system fitted which will activate if the air inlets or heater outlets are obstructed. For safety reasons the fire
WILL NOT switch on again automatically. NOTE: The LCD display panel will remain operational if the cut-out is activated, only the fan heater
elements are prevented from operating.
The following procedure must be carried out before the fire can be operated again:
1. Unplug the power supply cable at the outlet socket and place all switches to off at the appliance.
2. Leave the fire OFF for a period of not less than 10 minutes, ensuring any obstructions are removed.
3. Plug in the power supply cable at the outlet socket, and then switch on at the appliance.
If an attempt to switch on is made before the safety cut-out has reset, the heaters may cut-out for a further period of time. If the sequence has
been followed correctly and the heaters still fail to function, check the power supply cable plug is plugged in at the outlet socket. If this is not
the cause, call an electrician.
ALWAYS DISCONNECT THE APPLIANCE AT THE SUPPLY OUTLET SOCKET BEFORE UNDERTAKING ANY CLEANING.
Except for periodic cleaning of dust, there are no specific requirements for care, other than regular cleaning of the general appliance. A wipe
with a dry cloth is normally sufficient. DO NOT use abrasive cleaners as they can damage the finish. Make sure the heater outlet grille (locat-
ed next to the sitches), and the air inlet mesh grilles (located either side of the outlet grille) are kept clear of dust, pet hair and other airborne
household matter. These should be vacuum cleaned periodically using a brush attachment.
PLASTIC SCREEN - This should only be cleaned using a suitable glass cleaner. Test on a small area first.
8.0 OPERATING THE APPLIANCE
- CONTINUED
GB IE
4
©
2011 Focal Point Fires plc.
Fig. 7 - Abstract scene
Fig. 8 - Nature scene
Fig. 9 - Aquarium scene
Fig. 4 - Gas fire (medium)
Fig. 5 - Gas fire (high)
Fig. 6 - Gas fire (Blue Flame)
Fig. 1 - Log fire
Fig. 2 - Twig fire
Fig. 3 - Coal fire
Scene
select
buttons
Volume
and
mute
buttons
Figure 10
9.0 SAFETY CUT-OUT SYSTEM
10.0 CLEANING AND MAINTENANCE
