9.0 OPERATING THE APPLIANCE - CONTINUED
7
GB IE
©
2019 Focal Point Fires plc.
Remote Operation
NOTE: The heater should be powered on using the ON/OFF switch before it can be operated using remote control.
The remote control requires 2xAAA size batteries (Not included).
Open the battery compartment by sliding the cover down and insert the batteries noting the polarity indicated in the battery compartment.
Keep batteries out of reach of children.
Remote control operations are identical to the functions on the control panel.
The remote control must be point directly at the sensor on control pad.
Display
Settings
Setting weekday and time
Press the DAY/TIME key. When the day is flashing press the
▲
or
▼
key to select the day.
Press the DAY/TIME key again, then press the + or – key to set the hour.
Press the DAY/TIME key again, then press the + or – key to set the minute.
Press the OK key to confirm the setting.
Switch the appliance ON
Set to standby mode
Go up in the menu
(change day)
Increase temperature
Increase hour/ minute
Set day/time
Set timer key
Go down in the menu
(change day)
Toggle between 5 different
flame brightness levels
Confirm selection
Cancel key
Set automatic heating mode
Press once to activate the low setting
Press twice to activate the high setting
Press a third time to switch the heater OFF
Toggle between the 7 different back light effects
Decrease temperature
Decrease hour/ minute
Timer on/off key
2x AAA, 1.5V
Standby mode icon
Automatic heating mode
Time/ temperature display
Timer ON
Timer OFF
Temperature/
timer number
Flame brightness level
Timer icon
Day of the week
Low heat setting
High heat setting
Heating level
