8.0 INSTALLING THE APPLIANCE - CONTINUED
6
GB IE
©
2019 Focal Point Fires plc.
For optimum viewing install the fire out of direct sunlight. Ensure that the bracket
is level by using a spirit level whilst marking out the hole positions. Fix the wall
bracket using the plugs and screws provided. Carefully lift the heater up ensuring
that the top rear ledge of heater engages with the wall bracket and is sitting cen-
trally. This process should be carried out by two people to avoid injury or damage
to property or the appliance (figure 3).
Gently bring the heater down against the wall. Mark both the lower fixing bracket
fixing hole positions on the wall, remove the heater. Drill the wall and insert the
wall plug. Refit the heater to the wall and fasten the bottom fixing bracket to the
wall using the screw provided to permanently fix the heater in place (Figure 4).
Place the front decorative glass fascia over the front of the fire aligning the slots in
the brackets at each side of the front panel with the lugs on the sides of the fire
(Figure 5). Again two people will be required for this operation.
Check that the fan outlet, mounted on top of the appliance, is not covered or
obstructed in any way. Ensure the power to the fire is switched ON.
Figure 3
Figure 4
Figure 5
460
160
9.0 OPERATING THE APPLIANCE
Switching ON/OFF
Use the ON/OFF switch to power on the heater (set it to standby mode).
In standby mode, the heater can be operated either manually by the switches located at the top and right hand side of heater or by the sup-
plied remote control.
Manual Operation
NOTE: The heater only starts working if the set temperature is higher than the ambient room temperature
Indicator lights
Buttons
Heater powered OFF
Heater powered ON, set to standby mode
Press to switch flame effect ON/ OFF
Press and hold to toggle between 5 different flame settings
POWER
Press once to activate the low setting (900W)
Press twice to activate the high setting (1800W)
Press a third time to switch the heater OFF
BACK LIGHT
Press to toggle between 7 different back light effects
