All models : Ensure all/any protective film is removed as the facia may be damaged if the fire
is lit with the facia in position whilst still covered in film.
P23 & L23 models: The facia panel is supplied attached to the fire. To remove the facia panel,
first, remove the lower retaining screws (one on each side of the appliance). Simply lift the
frame upwards. Refitting is the reverse of removal. Ensure the cut-outs in the bottom of the
frame support brackets engage the lower screws on each side of the appliance. See figure 10.
L23 models :. The glass facia panel is supported by four M6 screws which protrude from
the front of the outer casing.
Ensure each screw is unscrewed approximately one turn from the fully screwed in posi-
tion in order to create a 2mm gap (shown in figure 11). Simply hang the facia panel onto
the outer casing ensuring that the corresponding keyhole shaped holes engage the screw-
heads fully (see figure 12).
8.3 FITTING THE DECORATIVE FRAME
7
©
2016 Focal Point Fires plc.
GB IE
Figure 10
Figure 12
1. Insert the
screws into
the threaded
holes provid-
ed on each
side of the
upper casing,
and hang on
the facia, via
the corre-
sponding
hooks on the
facia support
brackets
.
2.Secure the
facia at the
bottom using
two more
screws in the
position
shown
2mm
Figure 11
