IMPORTANT NOTES
This appliance is a catalytic flueless flame effect gas fire, providing radiant and convected warmth. It is designed
to operate on Natural Gas following factory set adjustments, (see Data Plate on appliance for gas type and pres-
sure).
It is the LAW that all gas appliances and fittings are installed by a competent person (such as a CORGI registered
fitter) and in accordance with the Gas Safety (Installation and Use) Regulations 1998, the relevant British
Standards for Installation, Codes of Practice and the Manufacturers' Instructions. The installation shall also be
carried out in accordance with the following regulations:
The Building Regulations issued by the Department of the Environment, the Building Standards (Scotland)
(Consolidation) Regulations issued by the Scottish Development Department.
Relevant British standards insofar as the relevant areas are not covered by these instructions.
Note: For Republic of Ireland, reference should be made to the relevant standards governing installation. (IS 813:
1996)
Failure to comply with these regulations could lead to prosecution and deem the warranty invalid.
This appliance must be installed in accordance with the rules in force and used only in a sufficiently ventilated
space. A minimum of 100cm
2
(15.5 in
2
) purpose provided ventilation is required for this appliance, an openable
window or louvre is also required. To reduce the possibility of draughts entering the room via the air vent, we
recommend the use of "Black Hole" or "Vortex" type vents featuring internal baffles.
It should be noted that heaters create warm air currents. These currents move heat to wall surfaces next to the
heater. Installing the heater next to vinyl or cloth wall coverings or operating the heater where impurities in the
air (such as tobacco smoke) exist, may discolour walls.
Consult ALL instructions before installation and use of this appliance.
This appliance is free from any asbestos material.
1
Section
Contents
Page No.
1.0
Important Notes
1
2.0
Appliance Data
2
3.0
Installation Requirements
2
3.1
Room Sizing
2
4.0
Site Requirements
2
4.1
Ventilation
3
5.0
Unpacking the Appliance
4
5.1
Component Checklist
4
6.0
Gas Supply Routes
4
7.0
Fixing the Appliance
5
7.1
Checking the Burner
5
Section
Contents
Page No.
8.0
Testing and Commissioning
6
8.1
Operating the Appliance
6
8.2
Spark Failure
6
8.3
Setting pressure
6
8.4 Fitting the Decorative Frame
7
9.0
Briefing the customer
8
10.0
Servicing
8
10.1 Servicing the Burner Unit
8
10.2 Pilot Assembly
9
10.3 Catalyst
9
10.4 Testing for Firebox Leakage
9
11.0
Troubleshooting Guide
10
User Instructions
1.0
