DO NOT
-
site in a position where curtains or drapes could cover the appliance.
-
site in a position where other soft materials could cover e.g. below a coat rack.
-
site behind an opening door where mechanical impact/damage could occur.
-
site where the supply cable would become a trip hazard.
-
sit, stand or forcefully pull on the appliance.
-
obstruct, cover or force items into the openings.
-
use the heater to dry clothes.
-
site/use in an outdoor location(s).
-
run the supply cable under carpets
.
-
Mount on a wall.
Read all the instructions before continuing to unpack or install this appliance. Carefully remove the appliance from its packaging and lay on the
floor with it’s back surface downward. Note: DO NOT stand the appliance on its frame as this may cause distortion. Check that the remaining
packaging contents correlate with the component checklist below. Please dispose of all packaging with care at your local recycling centre.
QUANTITY
DESCRIPTION
1
Heater main body
1
Decorative Frame
1
Decorative Fret with aspan door
1
Neoprene securing strip
1
Loose coal set (only available with Lulworth model)
1
Loose pebble set (only available with Lulworth model)
1
Instruction Booklet
3.0 INSTALLATION REQUIREMENTS -
CONTINUED
GB IE
4.0 UNPACKING THE APPLIANCE
'
2014 Focal Point Fires plc.
3
5.0 COMPONENT CHECKLIST
6.0 INSTALLING THE APPLIANCE
Dependent on your installation requirements, you may wish to install the appliance in three different ways.
1: Flat wall - If you are putting the fire against a wall with no recess, you will use both of the spac-
ers that are fitted to the fire. You will be able to use either the sticky double sided neoprene strips,
or, secure the fire to the wall using the key hole slots on the rear of the spacer frame with screws.
2: Semi recessed - If you are putting the fire against a wall with a recess of 60mm or more, you
will be able to remove one of the spacers that are fitted to the fire, so that your fire can sit fur-
ther back on the hearth. You will be able to use either the sticky double sided neoprene strips, or,
secure the fire to the wall using the key hole slots on the rear of the spacer frame with screws.
See section 7.0 Removing the appliance spacer frame.
Method 1 - Installation with spacer(s)
Neoprene - To use the Double sided Neoprene strip, you will need to cut the length into three equal pieces. Install one either side of the bot-
tom rear of the spacer and one on the top center of the spacer.
Flat wall installation
Semi recessed installation
Fully recessed installation
