8.0 INSTALLATION - CONTINUED
GB IE
5
©
2016 Focal Point Fires plc.
Installing the wall plugs into the wall.
1. Offer the appliance up to the wall in it’s desired location.
Draw a mark where you wish to connect the straps in to
the wall. Remove the appliance from the position and drill a
hole (5.5mm diameter, 40mm deep) each side.
Please note: Before drilling into walls, always check
that there are no hidden wires, pipes, etc. Make sure
that screws and wall plugs supplied are suitable for
supporting the unit in your surface. Consult a
qualified person if you are not sure.
Inserting the wall plugs into the wall.
Gently hammer the wall plugs into position.
Installing the appliance to the wall.
Using a screw driver screw through the washers and the
fixing straps and into the wall plugs you have just installed
into the wall. Securing the appliance into position.
9.0 OPERATING THE APPLIANCE
The control panel is located at the top right hand side of the
appliance.
When a function is changed from the control panel or remote there will be a corresponding
indicator displayed. The indicator shows the function changed and the level selected. When the
function is turned off, the corresponding indicator will fade off.
Figure 4
Figure 3
Figure 2
