Focal 922-MES, Руководство пользователя

Страница: 38 / 40

Model 922-MES
– User Manual
Focal Technologies Corporation Page 9-1
A Moog Inc. Company Document No. 922-0662-00, Rev 1.0
9.0
Diagnostics and Control
Remotely accessible, real-time diagnostic data and status information is available from the 922-MES. This
information can be used for real-time health monitoring and long-term trending of critical parameters for
predictive analysis.
Ethernet Diagnostics (Modbus TCP/IP and Telnet): The Ethernet interface provides full diagnostics and
control of the card. Diagnostics and status information are retrievable using Modbus TCP/IP and/or Telnet over
any Ethernet port (copper or SFP).
Configuration options include:

Ethernet port control registers (e.g. forcing speed/duplex, rate limiting, aging, broadcast protection,
port priority, virtual local area network (VLAN) configuration, etc.)

Field update of embedded firmware, and user-controlled switching between stored firmware versions.
Factory Serial Diagnostics (RS-232): The RS-232 serial interface provides basic read-only diagnostics
information via a non-isolated interface (J3). It is intended for factory bench testing and debugging purposes
only. See section 6.6 for details.
Diagnostics information and control provided by the card is shown in the table below.
Table 9-1: Diagnostics Information
Diagnostics Type Description
Ethernet
Telnet Modbus
UDP
(long)
UDP
(short)
Ethernet Copper Ports
Link speed status (10/100/1000M)
  
Link speed configuration (10/100/1000M)
 
Duplex mode
 
Autonegotiation state
 
Ethernet SFP Ports
Link speed (100/1000M)
  
Link speed configuration (100/1000M)
 
Redundancy Mode
MRP Status (MRC/MRM SFPs only)
 
MRP configuration
 
RSTP Status (Copper ports only)
 
RSTP configuration
 
Optical SFP
Optical Tx/Rx power levels, Tx bias current, voltage
and temperature
 
Serial number and wavelength

On-board Sensors
Board temperature
   
Humidity
   
ON time counter
   
OFF event counter
   
Network, Analog Data and
Board Serials
Network settings and configuration (IP address,
Subnet Mask, Gateway, DNS, DHCP)
   
Analog data (on-board voltage rails and board current)
   
Board serial information (including serial number, date
code, FW version, MAC address)
   
Notes:
1. Diagnostics data shown is for cards with uC DIAG FW version
≥
0xA3 where

= Diagnostics capability available. Blank =
Diagnostics capability not available.