5
9.0 CLEANING
Before carrying out any of the following operations, ensure that the appliance is OFF and completely cold. Regularly clean around the
appliance to ensure that dust, fluff, pet hair etc, are kept to a minimum. There are no other specific requirements for care, other than
regular cleaning of the general appliance.
A wipe with a dry cloth is normally sufficient. DO NOT use abrasive cleaners as they can damage the finish. Metal parts may be cleaned
using an appropriate metal cleaner. Test on a hidden part before cleaning. Clean only in the direction of the grain.
GLASS PANEL - This can be cleaned with a suitable glass cleaner. Test on a small area first.
PAINTED AREAS - These can be cleaned using a dry cloth.
CERAMICS - Remove the ceramic components. Gently clean in the open air. Be careful not to create dust from the logs. Where neces-
sary replace damaged components with genuine spares. Seal scrap components in plastic bags and dispose of at proper refuse sites as
directed.
10.0 REPLACING THE BATTERY
Ensure appliance is off and cool. The battery is located in the front of the ignition unit, on the
right hand side of the burner (Shown in figure 13). Unscrew the battery holder cap. Insert 1 x
‘AA’ (1.5 volt) battery. Replace cap. This can be achieved without removing the castings.
Figure 13
© 2014 Focal Point Fires plc.
GB IE
11.0 LIST OF REPLACEMENT PARTS
The Installation instructions carry full servicing details for the use of the installer.
PART NO.
ITEM
F550436
Ceramic log set
F550433
Ceramic brick tiles
F550435
Glass tiles
F550339
Glass door assembly
F730067
Gas valve
F730069
Pilot assembly (Natural Gas)
TBC
Pilot assembly (LPG - Propane)
F730070
Injector - (Natural Gas 1.30)
F730104
Injector - (LPG - Propane .83)
F510127
Burner unit (Natural Gas)
F510133
Burner unit (LPG - Propane)
F780079
Catalyst
F740004
Ignitor
