Turbo Stream
11
Installation and Operation Manual
11
Engine Operating Instructions
PREPARATIONS BEFORE STARTING THE
SYSTEM
1) Fuel: Check fuel level in tank. Do not overfill tank.
Use fresh, clean automotive fuel. NOTE: DO NOT
FILL FUEL TANK WHEN ENGINE IS RUNNING.
2) Engine Oil: Before checking or refilling with engine
oil, make sure the engine is stopped and placed on
a stable, level surface. Use oil recommended for
ambient air temperatures at which the engine will
be running. Change oil according to manufacturer’s
recommendation. (At least once after the first 20
hours and every 100 hours thereafter.)
3) Pump Oil: Before checking or refilling with pump
oil, make sure the engine is stopped and placed on
a stable, level surface. Use oil recommended for
ambient air temperatures at which the pump will be
running. Change oil according to manufacturer’s
recommendation, using SAE 30 weight non-
detergent oil. Check oil level before running the
system using the oil level dip stick on the pump.
4) Gear Case Oil: Before checking or refilling with
gear case oil, make sure the gear case and engine
are stopped and placed on a stable level surface.
Use oil recommended for ambient air temperatures
at which the gear case will be running at. Change
oil according to manufacturer’s recommendation,
using SAE 90 weight non-detergent oil. Check oil
level before running the system using the oil level
hole on the side of the gear case.
5) Check to see that water supply lines, strainers and
foam tank lines are free of debris and plumbed
correctly. Any leaks in the system will cause poor
system performance and operation.
STARTING THE SYSTEM
IMPORTANT:
Before starting engine, be sure
discharge hose is secure.
1) Turn the engine switch located by the recoil starter
to the ON position.
2) Turn the fuel cock to the ON position.
3) Push the throttle lever to a slightly open position.
4) Operation of the choke lever
a) When engine is cold:
i) In cold weather, start engine with choke in
the fully-closed position.
ii) In warm weather, start engine with choke in
half-closed position.
b) When engine is warm:
i) Start engine with choke in fully open position.
5) Open the gun by pulling the trigger. This will allow
easier starting of the engine.
6) Start the engine with electric start key or recoil
starter.
OPERATION OF THE SYSTEM
1) Idle the engine for 3 to 5 minutes or until operating
temperature is achieved.
2) CAUTION: Do not run the FoamPro High Pressure
System for long periods during unloading. Long
periods of pump deadheading may result in pump
damage due to overheating of water in the system.
3) Open the throttle lever to the upper zone after
engine has reached operating temperature.
4) Once the system is primed, you will note a load on
the engine; adjust RPM to proper speed for your
pumping application.
5) Adjust the foam concentrate injection percentage
with the display panel to the desired percentage
while the system is running at full capacity (8 GPM).
STOPPING THE SYSTEM
1) Stop pump for a short time:
a) Run throttle all the way down (fully to the right).
b) Turn engine switch to OFF position.
c) Turn the fuel cock to the OFF position. This
valve should be closed for transporting the
unit also.
2) Stopping pump for storage:
a) Turn fuel cock to OFF position instead of
turning the engine off.
b) Let the engine idle for 2 to 3 minutes until fuel
in the carburetor is depleted and engine stops.
c) Drain the pump and flush pump after use.
d) Drain all fuel from engine.
e) Store system in clean, dry environment.
