FoamFly FAT P-47, Инструкция по эксплуатации, Страница: 9 / 13

7
f) Glue the Control Horns into the Surfaces.
i)
The Rudder Control Horn goes on the side of the rudders angled so
that it will point at the servo location.
ii) The Elevator Control Horn goes on the underside of the Elevator,
on the same side as the rudder horn. Make small cuts with your X-
Acto knife where the control horns will line up with the pushrods,
and press fit the control horns in place. Make sure the holes are
lined up directly over the hinge line, and hot glue weld them in
place.
iii) Run the pushrods as straight as you can. A small piece of tubing
(Like a cocktail straw) works great as a support.
g) Mount the motor on the stick.
h)