FMS RTM MP EMGZ443MP.R, Руководство по эксплуатации

Страница: 9 / 28

Operation Manual RTM MP System
06.09.2017 9
4 Installation and Wiring
4.1 Area of Machine Rotation
Following RTM MP components are installed either on the rotating part of the
machine or in the area of machine rotation:
● RMGZ Force Measuring Rollers
●
Transmitter EMGZ482T.MP.24VDC
● Multi-purpose extension module EMGZ443MP.T
4.2 Force Measuring Sensors on the Static Machine Area
The red point should always be
aligned in the direction of the
resulting Force (see Fig. 2). For
further mounting information
please consult the respective
installation manual of the
sensor. The installation manual
is always delivered together with
the sensor.
4.3 Force Measuring Sensors on a Rotating Machine Part
Note
In rotating applications the force measuring sensors are mounted such that
centrifugal forces are compensated. If using FMS RMGZ sensors, this can be
achieved by turning the Red Point parallel to the rotation axis and in direction of the
positive force component (refer to Fig. 3).
Note
The adjustment of the red point can be tested after offset compensation and
calibration. If the reading of an unloaded load cell stays at zero regardless of the
load cell position (e.g. at 12 o’clock or at 6 o’clock position), the red point is
correctly aligned.
Fig. 2: RMGZ Red Point alignment on static
machine parts
RTMX2 0028e