FMS Eazy RC 540mm PA-18 Super Cub, Инструкция по эксплуатации

Страница: 8 / 24

Binding Instruction
Binding is the process of programming the receiver to recognize the GUID(Globally Unique
Identifier) code of a single specific transmitter. When a receiver is bound to a transmitter, the
receiver will only respond to that specific transmitter.
Binding steps：
1.Keep the transmitter switched OFF, throttle joystick at buttom position.
2.Connect the battery to the plane, then turn on the transmitter within 5 seconds.
3.The receiver LED will flash for 3-8 seconds to bind automatically.
4.After the receiver LED stop flashing, it means the binding process is done.
NOTICE：Keep Gyro switch at Middle or Beginner position.
NOTICE：Keep the planes til in a calm environment for calculating the Gyro.
Throttle Unlock(Arming)
To prevent from damages, the throttle channel is locked each time when powering on your
transmitter. Follow below instruction to unlock the throttle.
Turn the throttle stick up to max position until you hear a"beep"sound.
Then turn the throttle stick down to min position until you hear a"beep"sound.
Now the throttle is unlocked.
CAUTION
：Keep the propeller in distance for your safety.
08
CN
Gyro Switch
Three modes available:
Manual/Gyro Off (EXPERT)
Soft Gyro Assit(MIDD)
Strong Gyro Assit (BEGINNER)
Soft Gyro Assit(MIDD)
Strong Gyro Assit
(BEGINNER)
Manual/Gyro Off
(EXPERT)
Soft Gyro Assit(MIDD)
Strong Gyro Assit
(BEGINNER)
Manual/Gyro Off
(EXPERT)
Transmitter Instruction
Power status LED
One-key Aerobatics
Button
One-key U-turn
Activation
Throttle
Rudder
Rudder trim
One-key U-turn Switch
Gyro Switch
Elevator trim
Elevator
Aileron
Aileron trim
Power switch
EN