FMS Eazy RC 540mm PA-18 Super Cub, Инструкция по эксплуатации

Страница: 11 / 24

Trouble shooting
Aircraft will not
respond to the
throttlebut responds
to other controls.
Extra propeller
noise or extra
vibration.
Reduced flight time
or aircraft
underpowered.
Control surface
does not move, or
is slow to respond
to control inputs.
Controls reversed.
-Motor loses power
-Motor power
pulses then motor
loses power.
LED on receiver
flashes slowly.
-ESC is not armed.
-Throttle channel is reversed.
-Damaged spinner,
propeller,motor or motor
mount.
-Loose propeller and spinner
parts.
-Propellor installed
backwards.
-Flight battery charge is low.
-propeller installed
backward.
-Flight battery damaged.
-Control surface, control
horn, linkage or servo
damage.
-Wire damaged or
connections loose.
Channels are reversed in
the transmitter.
-Damage to motor, or
battery.
-Loss of power to aircraft.
-ESC uses default soft Low
Voltage Cutoff(LVC).
Power loss to receiver.
-Lower throttle stick and throttle trim to
lowest settings.
-Reverse throttle channel on transmitter.
-Replace damaged parts.
-Tighten parts for propeller adapter,
propeller and spinner.
-Remove and install propeller correctly.
-Completely recharge flight battery.
-Replace flight battery and follow flight
battery instructions.
-Replace or repair damaged parts and
adjust controls.
-Do a check of connections for loose
wiring.
Do the control direction test and adjust
controls for aircraft and transmitter.
-Do a check of batteries, transmitter,
receiver, ESC, motor and wiring for
damage(replace as needed).
-Land aircraft immediately and recharge
flight battery.
-Check connection from ESC to receiver.
-Check servos for damage.
-Check linkages for binding.
Problem Possible Cause Solution
11
EN