Operating Manual AZS01B and AZS04B
14.08.2018
9
6.2
Adjustment of the Sensors
Fig. 4: Position of the sensors according to the web
1
Material edge
2
Centre axis of detection range
3
Material offset
4
Detection range
5
Positioning reference marks
1.
Loosen the fixation nut on the bracket and slide the sensor into position.
2.
Position the web in the sensor
3.
The positioning marks provide a quick and precise alignment of the sensor to
the reference edge.
4.
Align sensor axis to the web edge
5.
Tighten the fixation nut with the sensor in the new position.
6.
The sensor will be properly positioned if the web edge runs through the sensor
axis covering half of the transmitter or receiver (ref. to Fig. 4).
7.
The LED in the connector socket will be active if the web is positioned in the
centre of the sensor area.
8.
Tighten the fixation nut.
9.
The sensor is now ready for use.
