FMN WZ FSE 2-2, Инструкция по эксплуатации, Страница: 27 / 52

26 27
7.4 Explanation of the error messages in the extended output mode
In case of malfunction, inform the customer service of the manufacturer about the exact error code. From the customer service you
will get the necessary instructions for remedy.
XX Meaning ERROR output
RS232 interface
01 Communication error on: active LOW 1)
02 Communication error on: active LOW 1)
03 Communication error on: active LOW
1)
04 Communication error on: active LOW
1)
General error messages
05 Programming of the frequencies was faulty on: active LOW
1)
06 The set channel number is faulty.
Remedy: set the correct channel number
on: active LOW 1)
07 Invalid power level.
Remedy: program a valid power level
on: active LOW
1)
Parameter memory
0A Error in the parameter memory off
0B Error in the parameter memory off
0C Error in the parameter memory off
0D Error in the parameter memory off
0E Error in the parameter memory off
Parameter memory
13 Error in the parameter memory on: active LOW
1)
14 Error in the parameter memory off
15 Error in the parameter memory on: active LOW 1)
Parameter memory
16 Error in the parameter memory on: active LOW
1)
17 Error in the parameter memory off
18 Faulty / invalid parameter on: active LOW
1)
Transmitter
19 Power level is insufficient, the transmitter has been deactivated. blinking 2)
1A Over-temperature protection in transmit mode, the transmitter will be neverthe-
less activated. off
1B Over-temperature protection in transmit mode; the maximum number of trans-
mit cycles has been achieved. The transmitter cannot be activated anymore.
Remedy:
1. Disconnect the WZ FSE from the power supply.
2. You can operate the unit again when it has
sufficiently cooled down.
off
1C Mismatching; the transmitter will be nevertheless activated.
Remedy:
1. Check the antenna cable for short circuits and
that it is not broken.
2. Use an antenna which is suitable for the
frequency range.
off
Troubleshooting