www.fmiproducts.com
125078-01B
15
Figure 16 - Installing Firestop
If area above is a living space, install
firestop below framed hole.
If area above is an attic or insulated area,
install firestop above framed hole.
Note: If vent pipe passes through any occupied ar-
eas above first floor, including storage spaces and
closets, you must enclose pipe. You may frame
and sheetrock enclosure with standard construc-
tion material. Make sure and meet the minimum
allowable clearances to combustibles. Do not fill
any required air spaces with insulation.
Vertical Termination Configurations
Figure 17 shows the configurations for vertical
termination.
venting inStALLAtiOn
Continued
Figure 17 - Vertical Venting Configuration
HIGH ALTITUDE INSTALLATION
Your FMI PRODUCTS, LLC direct vent
fireplace has been tested and approved for
elevations from 0-2000 feet.
Fireplaces for high altitude (-HA Models) are
for installations above 4,000 feet only. These
fireplaces are equipped with parts specific for
higher altitudes.
When installing a non-high altitude fireplace at
an elevation above 2000 feet, you may need
to decrease the input rating by changing the
existing burner orifice to a smaller size. Reduce
input 4% for each 1000 feet above sea level.
Check with your local gas company for proper
orifice size identification.
When installing this fireplace at an elevation
above 4500 feet, check with local authorities.
PARTS LIST FOR VENTING KITS
AND COMpONENTS
FMI (5/8") Pipe & Vent Kits
Number
Description
P58-6
6" Section Double Wall Pipe,
Galvanized
P58-12
12" Section Double Wall Pipe,
Galvanized
P58-24
24" Section Double Wall Pipe,
Galvanized
P58-36
36" Section Double Wall Pipe,
Galvanized
P58-48
48" Section Double Wall Pipe,
Galvanized
PA58-712 Adjustable 7"-12" Section Double
Wall Pipe, Galvanized
E58-45
45° Elbow, Galvanized
E58-90
90° Elbow, Galvanized
HTS-58 Horizontal Square Termination,
Galvanized
HHT-58 High Wind Round Termination,
Galvanized
VT-58
Vertical Round Termination,
Galvanized
SC-58
Storm Collar, Galvanized
WF-58
Wall Firestop, Galvanized
RF-58-6 Roof Flashing - 0 to 6/12 Pitch,
Galvanized
RF-58-12 Roof Flashing - 6/12 to 12/12 Pitch,
Galvanized
VR-58
Vertical Restrictor, Galvanized
S-58
Vinyl Siding Standoff, Galvanized
WS-58
Wall Strap
CS-58
Cathedral Ceiling Support
FP-58
Firestop Plate
SF-58
Stucco Flashing - For use with
HTS-58
RF-58
Flat Roof Flashing
Vertical
Venting
V = 40' max.
