www.fmiproducts.com
112127-01E
16
INSTALLATION
Continued
Equipment
Shutoff
Valve
Gas Valve
Gas
Meter
Figure 19 - Checking Gas Joints for
Natural Gas Burner System
PRESSURE TESTING BURNER SYSTEM
GAS CONNECTIONS
1. Open equipment shutoff valve (see Fig-
ure 17, page 15).
2. Open propane/LP supply tank valve for
propane/LP burner system or main gas
valve located on or near gas meter for
natural gas burner system.
3. Make sure control knob of burner system
is in the OFF position.
4. Check all joints from equipment shutoff
valve to thermostat gas valve (see Figure
18 for propane/LP or Figure 19 for natu-
ral). Apply commercial leak test solution
to all gas joints. Bubbles forming show a
leak. Correct all leaks at once.
5. Light burner system (see
Lighting Instruc-
tions
, page 20). Check all other internal
joints for leaks.
6. Turn off burner system (see
To Turn Off
Gas to Appliance
, page 21).
INSTALLING OPTIONAL WALL
MOUNT SWITCH - GWMS2
1. Connect one terminal of 25 ft. wire for the
wall switch to the TPTH terminal on the
valve. Connect remaining wire terminal to
the TH terminal on the valve. Make sure
that the wire terminals are in the positions
on the unit as pictured in Figure 20. If
wires are not connected as shown, the
switch will not work.
2. Route the 25 ft. wire through openings
provided on the sides of the burner system
to a convenient location to mount your
switch.
Figure 20 - Control Valve Terminals
To Control
Switch or
Optional
Accessory
3. Connect one bare wire end to each of the
terminals of the GWMS2 wall switch.
4. Install the wall switch and cover in the
wall.
BURNER SYSTEM
ASSEMBLY
INSTALLING B-VENT BURNER
SYSTEM INTO STOVE BODY
1. Carefully lift burner system and place into
stove body from the rear of stove.
2. Discard center grate top of stove and re-
place with center grate top provided with
Cast Iron Stove Body.
INSTALLING REAR COVER
1. Place rear cover behind stove body. Rear
cover will rest on the bottom ledge of the
stove body.
2. Using hex screws provided, attach rear
cover to back of stove body. See Figure
22, page 17.
IMPORTANT
: This rear cover
must be securely in place before venting
pipes are installed.
3. Open lower door panel. The valve is
attached to the underside of the burner
system assembly.
4. Connect or reconnect gas supply, see
Connecting Stove/Burner System to Gas
Supply
on page 14.
WARNING: A qualified in
-
staller or service person must
connect burner system to gas
supply. Follow all local codes.
