www.fmiproducts.com
116239-01M
25
FIREPLACE INSTALLATION
Continued
Removing Louver Panels
Remove top and bottom louver panels by
simultaneously pulling both top end spring
latches towards center of appliance until
they are disengaged from locating holes
(see Figure 39). Repeat for bottom spring
latches and pull louvers outward. To install
or replace items removed, simply reverse
procedures above.
Figure 39 - Removing Louver Panel
Removing Screen Door Assembly
(KCC42 Series)
Push screen door assembly in toward the
bottom left and right sides until the magnetic
door latch pops the screen door out. Hold
the screen door assembly at the bottom and
swing the door up to disengage the tabs on
the top of the door from inside the slots un
-
derneath the upper face.
Figure 41 - Removing/Replacing Glass
Door
Lock
Unlock
Glass Frame
Assembly
Screw
Hinge
Latch
Spring
Latch
Louver
Panel
Figure 40 - Removing/Replacing Screen
Door Assembly (KCC42 Series)
Magnetic Door Latches
(KCC42 Series)
Door ScreenTabs
(KCC42 Series)
Slots underneath
Upper Face
Replacing Screen Door Assembly
(KCC42 Series)
Push magnetic door latch out to the open
position. Position screen door tabs with slot
openings in upper face frame. Swing door
screen assembly in towards the bottom face,
4. Remount new frame at hinge with five
new screws before closing door. This will
ensure seating of gasket.
5. Close glass door frame. Lock latches by
placing bar under tab on door and pushing
down and back on latch (see Figure 41).
6. Replace screen/rod assembly by revers
-
ing step 1, page 25.
7. Replace louvers by reversing procedure
under
Removing Louver Panels,
for KC42
series.
8. Replace screen door assembly, see remov
-
ing screen door assembly, see Figure 40
(KCC42 series).
Cleaning Glass Door
See
Cleaning and Maintenance
on page 30.
Press in on the bottom of door screen until
magnetic door latch is pushed in.
Removing Glass Door
If replacement of glass is necessary, entire
assembly, glass and frame, must be replaced.
If glass is broken, wear gloves and tape re
-
maining fragments onto frame.
1. Remove screen assembly by pushing
rod either left or right and then down and
forward to remove screen/rod assembly
from firebox. Set assembly aside.
2. Lift up on latches to unlock. There are two
on top of firebox and two below firebox that
hold glass door in place (see Figure 41).
3. While holding glass door to prevent it from
falling and causing injury, remove five
screws from hinge located on left side of
door frame assembly (see Figure 41).
