13
107599
OWNER’S MANUAL
For more information, visit www.desatech.com
UP
VENTING
INSTALLATION
Continued
3.
Attach vent pipe assembly to the
burner system. Set stove in front of it’s
permanent location to insure minimum
clearances. Mark the wall for a 10"
square hole (for noncombustible ma-
terial such as masonry block or con-
crete, a 7
1
/
2
" diameter hole is accept-
able). See Figure 27. The center of the
hole should line up with the center-
line of the horizontal rigid vent pipe.
Cut a 10"x10" (254mm x 254mm)
square hole through combustible ex-
terior wall (7
1
/
2
" [190mm] diameter
hole if noncombustible). Frame as
necessary (see Figure 27).
Figure 26 - Rigid Vent Pipe Connections
Female
Locking
Lugs
Male
Slots
WARNING: Do not recess vent
termination into any wall. This
will cause a fire hazard.
4.
Apply a bead of non-hardening mastic
around the outside edge of the vent cap.
Position the vent cap in the center of
the 7
1
/
2
" or 10" hole on the exterior
wall with the word “up” on the vent cap
facing up. Insure proper clearance of
1" to combustibles is maintained. At-
tach the vent cap with four wood screws
supplied (see Figure 28).
Note
: Re-
place the wood screws with appropri-
ate fasteners for stucco, brick, concrete,
or other types of siding.
For vinyl siding, stucco, or wood ex-
terior use vinyl siding standoffs be-
tween vent cap and exterior wall. The
vinyl siding standoff prevents exces-
sive heat from melting the vinyl sid-
ing material. Bolt the vent cap to the
standoff. Apply non-hardening mastic
around outside edge of the standoff in-
stead of the vent cap assembly. Use
wood screws provided to attach the
standoff. See Figure 29.
5.
Slide the wall thimble over the vent
pipe before connecting the horizontal
run to the vent cap (see Figure 30).
6.
Carefully move the stove with vent as-
sembly attached toward the wall and
insert the vent pipe into the horizontal
termination. The pipe overlap should
be a minimum of 1
1
/
4
". Apply silicone
to the outer pipe connection. Fasten all
vent connections with screws provided.
7.
Slide the wall thimble against the inte-
rior wall surface and attach with screws
provided (see Figure 30).
Figure 29 - Installing Vinyl Siding Standoff
Cut Vinyl Siding
Away to Fit
Standoff
Standoff
Wood
Screw
Bolt
Vent
Cap
Nut
Apply Mastic
to All Four
Sides
UP
(Framing
Detail)
10"
(254mm)
10"
(254mm)
7
1
/
2
"
(190mm)
Vent Opening
Combustible Wall
Vent Opening
Noncombustible Wall
Figure 27 - Vent Opening Requirements
Figure 28 - Installing Horizontal Vent Cap
Wood
Screw
Vent Cap
Apply Mastic
to All Four
Sides
Interior Wall
Surface
Horizontal
Vent Pipe
Screw
Vent Cap
(Horizontal
Termination)
Figure 30 - Connecting Vent Cap with
Horizontal Vent Pipe
Decorative Wall
Thimble
Continued
Wall
Thimble