www.fmiproducts.com
110398-01F
17
O
F
F
P
ILO
T
O
N
H
I
L
O
Figure 21 - Installing Log set (Top View)
Logs
Burner Ports
Figure 19 - Installing Center Insert Log (#3)
Center
Insert Log
(#3)
3. Place top left log (#4) and top right log
(#5) as shown in Figure 20.
4. Make sure open areas of logs line up with
burner ports (see Figure 21). Logs will fit
securely on chassis.
IMPORTANT:
Make sure log does not
cover any burner ports.
5. Place lava rock around base of heater if
desired.
O
F
F
P
ILO
T
O
N
H
I
L
O
Figure 20 - Installing Top Left (#4) and Top
Right Log (#5)
Top Left
Log (#4)
Top Right
Log (#5)
OPERATION
INSTALLATION
Continued
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per
-
sonal injury or loss of life.
A. This appliance has a pilot which must
be lighted by hand. When lighting
the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn by
hand, don’t try to repair it, call a quali
-
fied service technician or gas supplier.
Force or attempted repair may result in
a fire or explosion.
D. Do not use this appliance if any part
has been under water. Immediately
call a qualified service technician to
inspect the appliance and to replace
any part of the control system and
any gas control which has been under
water.