www.fmiproducts.com
125024-01A
17
INSTALLATION
Continued
5. Remove heater base from fireplace.
6. If installed, disconnect AUTO/OFF/ON
switch wire from control valve at TPTH
and TH locations (see Figure 19).
7. Connect wires from hardware pack (with
remote receiver bracket) to control valve
at the TPTH and TH locations as shown
in Figure 19. Connect other ends of these
wires to remote receiver wires.
Note: Make sure excess wire does not
interfere with burner or pilot.
8.
If heater was removed from fireplace be
-
fore installation of remote accessory, see
Installing Heater Base Assembly
on page
12 to reinstall heater into fireplace. Test gas
connection for leaks (see
Checking Gas
Connections
, page 15).
9. If logs were removed from heater for install
remote accessory, replace logs (see
In-
stalling Logs
,
Embers and Lava Rock
).
10. Place remote receiver on fireplace floor
next to control valve. Make sure the
remote receiver and wires are not on
or touching either gas burner on the log
set.
Installing Batteries for Remote Receiver
and Hand Held Remote Control
Two 9-volt alkaline batteries (not included) are
required to operate this heater with the wireless
hand-held remote control set. One battery must
be installed in the receiver and one in the hand-
held remote control unit.
Note: Only use alkaline batteries.
Figure 19- Disconnecting Switch from
Control Valve
Switch
Control
Valve
INSTALLING LOGS, EMBERS AND
LAVA ROCK
WARNING: Failure to posi
-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With heater set to Hi, check to
see if flames contact any log. If
so, reposition logs according to
log installation instructions in
this manual. Flames contacting
logs will create soot.
VCC & EMC Model Series
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place rear log (#1) on base assembly
as shown in Figure 20. Log will fit over
right end of burner and rest in middle of
U-burner.
Figure 20 - Installing Log #1
1
f i r e - p a r t s . c o m