www.desatech.com
115425-01E
6
into room, extinguish flame and remove any
obstruction.until.proper.venting.is.achieved.
Chimney flue must remain open a minimum of
3".at.all.times.during.operation.of.log.set.
INSTALLING DAMPER CLAMP
Secure. damper. stop. clamp. provided. to.
leading edge of damper as shown in Figure
3. If for any reason this clamp doesn't work
on your fireplace, another suitable clamp or
permanent stop must be installed, or damper
blade.must.be.cut.or.removed.
For Massachusetts Residents Only:
. In-
stallation. of. this. vented. gas. log. set. in. the.
Commonwealth of Massachusetts requires
damper be permanently removed or welded
in.fully.open.position.
INSTALLATION
Continued
Figure 3 - Attaching Damper Clamp
Manufactured.
Fireplace
Masonry.
Fireplace
Damper
Damper
Damper.
Clamp
Damper.Clamp
CONNECTING TO GAS SUPPLY
WARNING: A qualified ser
-
vice person must connect log
set to gas supply. Follow all
local codes.
Installation Items Needed
Before installing log set, make sure you have
the items listed below.
•. piping.(check.local.codes)
• sealant (resistant to Propane/LP gas)
•. equipment.shutoff.valve
•. test.gauge.connection
• adjustable (crescent) wrench or pliers
•. sediment.trap
• tee joint
• pipe wrench
CHECK GAS TYPE
Use. only. natural. gas.. If. your. gas. supply. is.
not natural gas, you MUST NOT install this
gas.log.set.
WARNING: This appliance is
equipped for natural gas. Field
conversion is not permitted.
If fireplace does not have a gas supply shutoff
valve, one must be installed.
VENTING SPECIFICATIONS FOR
INSTALLATION
Fireplace chimney flue and vent must be draft
-
ing.properly..To.check.vent.for.proper.draft-
ing: Light a tightly rolled newspaper on one
end and place inside front edge of fireplace.
Observe.smoke.and.be.sure.vent.is.properly.
drawing smoke up chimney. If smoke spills out
Model
Burner
Description
BTU Input
(Natural
Gas)
Minimum
Flue
Opening
PHK18
BCS18
18".Ramp
57,000
8"
PHK24
BCS24
24".Ramp
80,000
8"
PHK30
BCS30
30".Ramp
90,000
8"
Minimum Fireplace Dimensions
Model
Front
Width
Back
Width*
Depth
Height
PHK18
BCS18
28"
18"
16"
18"
PHK24
BCS24
36"
23"
16"
18"
PHK30
BCS30
42"
29"
18"
18"
*.At.depth.Indicated
Figure 2 - Technical Information Charts
Fuel Inlet Pressure
Specifications (W.C.)
Min.
Max.
N.G.
5.5"
10.5"
Burner Orifice Sizing
Log Size
Natural Gas
In.
Num.
18"
0.120
31
24"
0.140
28
30"
0.1495
25
