FlyTek CLICK PRO, Руководство по эксплуатации и обслуживанию

Страница: 18 / 22

Your Click Pro coffee machine is equipped with an efficient steam system. To use it, you have to turn on
the heating light (ref. C), so that the boiler can heat up. Wait approximately two minutes for the boiler to
reach the ideal operating pressure. Check on the steam boiler pressure gauge (ref. O) that the pressure is
approximately 2.1 bar: when this occurs, the boiler is ready to generate steam.
To generate steam insert the steam wand (ref. M) into a cup or any other recipients containing the liquid
to be heated or emulsified (e.g. milk) and turn the steam knob (ref. I) anticlockwise until the correct steam
intensity is reached. Once you have obtained the desired result, turn the same knob (ref. I) clockwise until
the steam output is completely stopped.
STEAM SYSTEM
While the machine is dispensing coffee, do not touch the steam wand and do
not expose your face to the hot parts of the machine (danger of burns). The
heating surfaces of the machine are subject to residual heat even after use!
18
The machine has been preset at the factory with a suitable programmed electronic dosing, which takes
into account the specific pressing and grinding of the pods provided by your Supplier. However, you can
customise and modify all pre-set coffee doses in this way:
Press and hold key 2 until the LED starts flashing (from this point on, programming must be carried out
within 15 seconds). To programme the machine for “short coffee”, first insert a pod, press key 0 to start
the coffee dispensing and press it again when the desired dose has been reached. To programme the
machine for “long coffee”, first insert a pod, press key 1 to start the coffee dispensing and press it again
when the desired dose has been reached.
PROGRAMMABLE ELECTRONIC DOSING
Please remember to use only pods provided by your Supplier. The use of
different pods from those for which the coffee machine was designed may not
guarantee the same dispensing quality.
If the tray is not emptied, water may leak out.
It is important to empty the drip tray (ref. A) after dispensing not more than 30 cups of coffee.
If instead you want to make a long coffee, you have to press key 1 on the control panel. Once you have
pressed one of the coffee dispensing keys, you have to wait about three seconds until the coffee starts
to flow out. Once the programmed dose has been reached, the coffee dispensing stops automatically
(except when you press key 2). If you want to stop the dispensing earlier, simply press the same key
again. Once the coffee has been dispensed, we recommend removing the pod to prevent it from sticking
as it dries.