FlyTek CLICK PRO, Руководство по эксплуатации и обслуживанию

Страница: 16 / 22

Remove the machine from the packaging and place it on a stable surface, suitable to support its weight,
near a suitable power socket. The coffee machine must be installed in an environment with a minimum
temperature of 15°C and a maximum temperature of 25°C. Keep the original packaging in all its parts for
possible future transport.
INSTALLATION
Remove the cup warmer (ref. G) to access the water tank. Remove the tank by pulling the black hook
upwards, as shown in Fig. A.
TANK FILLING
16
WE RECOMMEND USING A SOFTENER AND ANTI-SCALE FILTER that needs to be periodically replaced.
Should this not be done, scale deposits may form inside the machine that could jeopardize its proper
functioning and the validity of the warranty. After having inserted the softener filter inside the tank, fill it
with drinking water, possibly with low calcium content. When finished, reinsert the tank into its seat by
pressing on the black hook, as shown in Fig. B, until it clicks into place.
The machine is equipped with a water tank level sensor. If the water in the tank reaches a level that is too
low, any ongoing coffee dispensing will be interrupted and the three LED lights on the control panel (ref.
D) will start to flash at the same time, indicating that the tank needs to be filled as explained above. To
avoid reaching this point, we recommend you to periodically check the water level.
If water freezes inside the machine system, disconnect the power plug, switch off the machine and
place it in a heated room with a temperature of at least 15°C. Wait about 30 minutes before switching
the machine on and using it again. To prevent the machine from freezing and for an optimal general
performance, we recommend using it in an environment with a temperature not below 15°C.
FIG. A
FIG. B