54
Function setup:
1. Enter the rate setting interface and set to
EXP2
,
LINE
.
2. Tap
Rate A,
the selected item will turn to light green.
3. Click
+
or
-
to set a appropriate rate value.
8.3.2 Setting Rate/EXP/Offset
Sets the related
Rate
,
EXP
and
Offset
after a line type
has been set. Take rate setting as an example.
For the setting of
EXP
and
Offset,
refer to the setting
of
Rate
.
8.3 Func. Rate(AFR)
Sets the curve type.
Note: This function is available for version 1.0.65 or above.
Tap to enter the corresponding rate setting interface of each channel.
Tap repeatedly to toggle among the curve type.
Display the real-time output rate of this function.
Tap to select
Rate B
.
Tap to select
Rate A
.
Display the real-time position of the control assigned to this function.
Tap to select
EXPB
.
Tap to select
EXPA
.
Tap to select
Offset
.
Display the real-time rate and line type.
Note:
RateA
is the ratio to the left of the neutral, and vice versa for
RateB
.
EXPA
is
the curve to the left of the neutral, and vice versa for
EXPB
.
Rate A/B
and
EXPA/B
are selected separately or fully depending on the curve type, when the curve type
is
EXP1
,
EXP1
can not be adjusted separately although it distinguishes between
A and B. When the curve type is
EXP2
,
SYMM
(symmetric), the rate and curve are
divided into A and B. A and B need to be set in linkage, and cannot be adjusted
individually. When the curve type is
EXP2
,
LINE
, the rate and curve are divided into
A and B, and both A and B can be adjusted separately.
Tap to enter interface of
DR rate
.
Note: The function shown in grey cannot be selected.
8.3.1 Setting Curve type
Function setup:
Enter the rate setting interface. Tap
EXP
,
SYMM
repeatedly
to toggle among the selections.
Please note that the data will be reset when the line type
is changed.
You can set servo volume change curves of all sticks, knobs, and switches assigned to the channel. You can switch to
different conditions to set different curves respectively. The servo volume change curve for the conditions controlled
by
DR
is set after enabling the
DR
. Those not supporting the assignment of the master control, such as Flap 2, cannot
be set. The allocation of the same function of different channels from any setting entrance into the settings is the
same. It is recommended that the
Func. rate
be set after the channel travel setting is completed. Any mixes source
will be applied the
Func. rate
function.
