HRZ00020&HRZ00017
Digital Proportional Radio Control System
6
4.5 Stick Calibration
This function is used to set the neutral position for throttle and wheel.
Every transmitter is calibrated before leaving the factory, however if recalibration is required, please follow these
steps:
1. Turn the steering wheel clockwise to the maximum and the trigger to the maximum externally. Power it on and
enter the stick calibration mode;
2. In the calibration mode, the buzzer prompts with cyclic fast beep twice, and the cycle period is 1 s;
3. When the steering wheel and the trigger are calibrated successfully, the buzzer stops prompting;
4. When the steering wheel and the trigger are calibrated successfully, operate the AUX3 key to exit the calibration
mode and save the calibration data. When the calibration fails, the operation of the AUX3 key is invalid and
data is not saved.
4.6 Power Off
Danger
•
Make sure to disconnect the receiver power before turning off the transmitter. Failure to
do so may lead to damage or serious injury.
Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2. Toggle the transmitter's power switch to the OFF positio
n.
1 . Tu r n o n t h e t r a n s m i t t e r w h i l e h o l d i n g t h e A U X 3 b u t t o n t o e n t e r b i n d i n g m o d e . L E D w i l l s t a r t
f l a s h i n g q u i c k l y.
•
Once in binding mode release the AUX3 button.
2 . T h e r e c e i v e r w i l l p o w e r o n a n d w a i t f o r 1 s e c o n d , i f w i t h o u t c o n n e c t i o n , i t w i l l e n t e r i n t o t h e
b i n d i n g s t a t e a u t o m a t i c a l l y ;
3 . A f t e r t h e b i n d i s c o m p l e t e d , t h e r e c e i v e r i n d i c a t o r l i g h t f l a s h e s s l o w l y, r e s t a r t t h e t r a n s m i t t e r
p o w e r, t h e t r a n s m i t t e r a n d r e c e i v e r i n d i c a t o r l i g h t i s a l w a y s o n .
N o t e : W h e n b i n d i n g , p u t t h e t r a n s m i t t e r i n t o b i n d i n g s t a t e f i r s t , t h e n t h e r e c e i v e r.
•
Applicable to the HRZ00020 transmitter and the HRZ00017 receiver. Different receivers have
different binding procedures. For more information, visit the FLYSKY website for manuals
and other related information.
•
Product information is updated regularly, please visit our website for more information.
