1.
SW2 reset button(CH4),
press and hold the SW2 button for several seconds, then CH4 takes
affect, otherwise, the CH9 takes affect.
• Press and hold SW2 button over 2S, the CH4 will reverse while the CH9 isn't changed.
• Press and hold SW2 button within 2S, the CH9 will reverse while the CH4 isn't changed.
2.
SW3 reset button(CH5) is four-wheel steering switch. The four mode will switch by pressing
the button once.
3.
SW4 reset button(CH6), the default output value is 1000us. When press the SW4 button
once, the output value will change to 2000us.The buzzer will prompt with 1 short beep when
switching to 1000us, and 2 short beeps for 2000us.
4.
SW5 reset button(CH7), to turn on/off winch function. The winch function is enabled when
the transmitter is powered on defaultly.
• When
winch function is enabled, CH7 value can be adjusted by ST+/- button.
• When
winch function is enabled over 3S and the ST+ button is not operated, the winch
function is disabled automatically, then CH7 outputs neutral value prompted with 2 short
beeps on tone 1.
Channels opration description
Failsafe
Stick Calibration
Data resetting
When the transmitter is turned on, keep the channel output at the desired value, then press and
hold the BIND button for 3S, after the buzzer prompts with long beep on tone 1, the failsafe is
set successful.
The default setting of the failsafe is no setting.
When the transmitter rebinds, the failsafe is reset to default setting.
1.
Turn the Steering Wheel to the Max endpoint in a clockwise direction and push the trigger
forward to its maximum endpoint while powering on the transmitter, then the transmitter
enters stick calibration mode.
2.
Turn the Steering Wheel or push the trigger to the Max or Min endpoint, then return to its
neutral point.
3.
After the calibration is finished, press the BIND button to exit the calibration mode. If the
calibration is failed, then the setting can not be saved by pressing the BIND button.
Follow the steps below to reset the data.
1. Press and hold the BIND button and the REV button while powering on the transmitter, the
data will be reset.
2. When the operation is successful, the buzzer will prompt with long beep on tone 2.
Follow the steps below to calibrate the transmitter.
