Basic Operations
Power on
Follow the steps below to turn on the transmitter:
1. Check to make sure that the batteries are fully charged and installed correctly.
2. Press and hold
Power Switch
until the LED indicator is solid on for 3S and then goes into
three-flash-one-off state, at the time, the transmitter is in standby mode. When the receiver
is connected to transmitter normally, the transmitter LED is solid on.
Controls
The ST+ and TH+ button are for increasing trim value defaultly, the buzzer will prompt with
tone 1 short beep when the trim is successful. One beep once for a press. when press for a
while, the buzzer will prompt with quick short beep. The buzzer will prompt with 2 short beeps
when the trim is over the mid-point. When the trim is at the end, the buzzer will prompt with
long beep.
Servo travel adjustment
CH1 servo travel can be adjusted by ST+/- button. The adjustment range is 0~120%, the step is
5%, and the default value is 100%.
CH2 servo travel can be adjusted by TH+/- button. The adjustment range is 0~120%, the step is
5%, and the default value is 100%.
Channel reverse
1. When the steering wheel is in the non-centering state, the channel 1 is reversed by pressing
the REV button, and switch once when the button is pressed.
2. When the throttle trigger is in the non-centering state and the steering wheel is in the
centering state, the channel 2 is reversed by pressing the REV button, and switch once when
the button is pressed.
3. If the CH5 four-wheel steering is in the rear-wheel-only steering mode, the reverse operation
is for CH5, not for CH1.
4. When the channel reverse takes affect by pressing the REV button, the buzzer will prompt
with 1 beep. The buzzer will prompt with 1 beep for CH1 and CH5 reverse, and with 2 beep for
CH2.
Binding
Follow the steps below to bind with the receiver:
1. Press and hold the BIIND button while turning on the transmitter,the transmitter LED will
flash fast.
2. Put the receiver into binding mode.
3. The binding process is finished when the transmitter LED stops flashing and is solid on.
4. Check to make sure the transmitter and receiver are working correctly, if there are any issues
or unexpected operation arise, follow the steps above to bind again.
Note: If the transmitter disconnects with the receiver, the transmitter LED will go into
three-flash-
one-off state
.
