Fault Finding Hints
Fails to Operate
1. Is the correct Starting procedure being followed?
See ‘Starting & Stopping’
2. Has the product overloaded ? See ‘Use’
3. Is the Power Turned On?
4. Is the Interlock Switch engaged?. See ‘Collection
Box’
5. Check the fuse in the plug, if blown replace.
6. Fuse continues to blow?
Immediately disconnect from the mains elec-
tricity supply and consult your local approved
Service Centre.
Debris Material is not pulled into the cutter.
1. By using the Push Stick, ensure the material is fed
far enough into the Feed Inlet
2. Ensure the Cutter is adjusted correctly, see
‘Adjustment’
3. Is the product running in the forward direction.?
4. If problem persists?
Immediately disconnect from the mains elec-
tricity supply and consult your local approved
Service Centre.
Poor Cutting of Debris Material
1. See ‘Adjustment’
2. If poor cutting persists
.
Immediately disconnect from the mains elec-
tricity supply and consult your local approved
Service Centre.
Debris Material is jammed in the Feed Inlet
1. Set the start switch to reverse.
2. Ensure the material is not too thick for the product.
Max diameter of twigs and branches is 40mm.
3. If problem persists?
Immediately disconnect from the mains elec-
tricity supply and consult your local approved
Service Centre.
Excessive Vibration
1. Disconnect from the mains electricity supply.
2. Ensure the Cutter is adjusted correctly, see
‘Adjusting the Cutting Plate’
3. If vibration persists?
Immediately disconnect from the mains elec-
tricity supply and consult your local approved
Service Centre.
Service Recommendations
•
Awareness of the environment must be considered when dis-
posing of ‘end-of-life’ product.
•
If necessary, contact your local authority for disposal informa-
tion.
The symbol on the product or on its packaging indicates that
this product may not be treated as household waste. Instead it shall
be handed over to the applicable collection point for the recycling of
electrical and electronic equipment.
By ensuring this product is disposed of correctly, you will help pre-
vent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate
waste handling of this product.
For more detailed information about recycling of this product,
please contact your local council office, your household waste dis-
posal service or the shop where you purchased the product.
Environmental Information
1. We strongly recommend that your product is serviced at least
every twelve months, more often in a professional application.
2. Always use genuine Flymo Spare Parts.
3. Prepacked spares are available from most Husqvarna
Outdoor Products stockists.
4. Your product is uniquely identified by a silver and black
product rating label
5. If you have a problem with your machine contact your local
Approved Service Centre ensuring you have full details of
your product as described on the product rating label.
6.
Should it be necessary for work to be carried out by your
Service Centre, it is important to take your complete
machine including cable and any extension cables used.
A network of specialist dealers can be found in your local
Yellow Pages. To obtain service on your Flymo product
simply telephone or visit your local Service Centre.
Should you require service under the terms of our guarantee
the Service Centre will require proof of purchase.
All of the centres listed stock genuine Flymo Spare Parts.
NOTE: Our Service Repairers act on their own behalf and
are not empowered to commit or legally bind Husqvarna
Outdoor Products in any manner whatsoever.
