Digital Proportional Radio Control System
12
FS-l6S
6. function Settings
This section details functions and their use.
6.1 Reverse
The reverse function changes a channels direction of movement in relation to its input. For example, if the
blades are spinning in the wrong direction, pushing the model into the ground instead of taking off, this
function can be used to correct this.
6.2 End Points
The end points function changes the range of movement available to a channel. This can be used to limit the
tilt of the model, so that it is easier to control.
The left box is the low end points, the right box is the high end points, marked below as low being blue and
red being high.
Setup:
To change between normal and reverse touch the box to the right
side of the desired channel.
Nor = Normal, Rev = Reverse.
Select the
icon to save and return to the previous menu.
Press the
To reset the function to its default settings.
Setup:
1. Touch the low or high end points box.
2. Touch the desired decimal to change then use the onscreen up
and down arrows to change the value.
6.3 Subtrim
Subtrim changes the center point of the channel. For example, if a model is always drifting to one side, the sub
trim can be used to fix this.
Setup:
1. Touch the box to the right of the desired channel.
2. Select the correct decimal and use the up and down arrow keys.