WARNING: Use common since when installing your lights and make
sure that your light, cables and battery don’t interfere with the proper
use of your handlebar or the control levers. Your handlebars should be
able to turn full left/right without binding or stretching cables or
interfering with the controls. If you’re not comfortable about your
installation, please have your Local Bike Shop install the lights for you.
Too many threads,
use a strip-spacer.
Cut strip-spacers as needed
Perfect threads
Stem mount battery pack
Frame mount battery pack
Handlebar mount battery pack
3. Handle Bar Mounting
•
Remove the screw from the handlebar mount and install the mount
on the bar with the release tab facing forward.
•
The rubber strip spacers included are used to achieve a proper fit
to your handlebars. The spaces can be trimmed with scissors to
achieve a good solid fit.
•
Re-install the mounting screw and tighten as needed to secure the
mount (Don’t over-tighten). The nut shouldn’t show more than two
threads above the surface. If too much thread is protruding, the
light will not slide onto the mount. Simply add an additional piece of
rubber strip as needed.
•
Find the most suitable place for
mounting the battery. If you have a long
enough stem, this is the best place to
put it; otherwise you can mount it to
your bike frame or handlebars
(Opposite side to where the light is).
•
Estimate how much cable length you
will require and then secure up the excess cable.
•
Wrap the Velcro strap around the stem/frame/handle bars, at the same time securing the
excess cable with a Velcro strap.
•
Plug the light cable into the battery cable.
