Fluke CableAnalyzer DSP-4100, Руководство пользователя

Страница: 137 / 216

Calibrations and Custom Test Standards
Configuring a Custom Test
6
6-5
During the configuration process, you can abandon the changes you have made by
pressing
! Abort
.
To reset a parameter back to the default value, highlight the parameter; then press
@ Set to Default
.
To reset all of the parameters back to default values, highlight the test standard on
Page 1 of the configuration screens; then press
E
. Use
U D
to select the
desired default standard; then press
E
.
To configure a custom test, proceed as follows:
1. Turn the rotary switch to SETUP.
2. Press
$ Page Down
until you see the CONFIGURE CUSTOM TEST
selection.
3. Highlight a custom test name. The default cable names are
* Custom
Cable 1*
through
* Custom Cable 8 *
. An asterisk always
proceeds and follows the name of a custom test configuration. Press
E
.
4. Use
U D
to select a parameter to change. Use
$ Page Down
to see
additional parameters. Press
E
to select a highlighted parameter for
editing.
Note
Selecting a default standard for a previously configured custom test
resets all test parameters to default values.
5. Use the appropriate keys to select the value you want; then press
E
.
If you selected to change the custom test name or the cable type, the
alphanumeric entry screen appears. Use the appropriate keys to enter a name
up to 27 characters long. When you are finished entering characters, press
S
.
6. Repeat steps 4 and 5 to change additional parameters.
7. When you are finished configuring test parameters, press
S
to store the
custom configuration.