Fluke CableAnalyzer DSP-4000 Series, Руководство пользователя

Страница: 120 / 228

DSP-4000 Series
Users Manual
5-4
•
Selected Autotest Reports
: Displays the SELECT
AUTOTEST REPORTS screen where you can select the reports you want to
print, as follows:
1. Use
# Page Up
,
$ Page Down
, and
D U
to highlight a
report label.
2. Press
E
to select the highlighted report. An asterisk appears on the
label to show that the report is selected for printing. To select several
consecutive reports, hold down
E
. To remove an asterisk, highlight
the report label; then press
E
.
3. To print the selected reports, press
! Start Print
; then press
E
. To stop printing and return to the main Print menu, press
e
.
•
All Report Summary
: Same as All Autotest Reports, except that
reports are printed in summary form. The summaries give the date and time
each report was saved, the cable identification entered for each report, and an
overall test result for each report.
•
Selected Report Summary
: Same as Selected Autotest Reports,
except that reports are printed in summary form.
•
Edit Report Identification
: Displays the REPORT
IDENTIFICATION screen, where you can edit the Custom Header, Operator
Name, or Site Name that appear on printed Autotest reports. This function also
appears in the SETUP mode. See "Editing the Report Identification" in
Chapter 2 for complete instructions.
To edit the cable identification assigned to a saved report, see "Viewing,
Renaming, and Deleting Test Reports" at the end of this chapter.
•
Edit Print Parameters
: Lets you change the Autotest report
format and configure the serial port.
When printing is complete, the test tool displays the following message:
Delete All Printed Reports?
. To delete the printed reports from
memory, press
# Yes
twice. To exit without deleting the printed reports, press
$ No
or
e
.