5
Measuring
Fluke 416D
GB
D
F
I
E
P
NL
DK
NO
S
FIN
GR
TR
CZ
SK
PL
HU
RU
RO
CN
KOR
the stop bracket with a little force to the right
side; the stop bracket can now be completely
unfolded. See drawing {
E
}.
CAUTION:
Make sure that when measuring from the
unfolded endpiece, the measuring reference point is
set to "End piece".
1x briefly: the next measurement is taken from
the front edge.
2x briefly: the measurement is taken from the
unfolded end piece.
After one measurement, the reference point returns
automatically to the default setting (rear reference
point).
1x long: the measurements are taken with the
front as reference until a new measuring refer-
ence point is set.
2x long: the measurements are taken from the
unfolded end piece until a new measuring refer-
ence point is set.
See drawing {
F
}.
Measuring
Single Distance Measurement
1x briefly: the laser is activated.
1x briefly: a distance measurement is taken.
The result is displayed immediately.
Continuous measurement
Distances can be measured with this function.
1x long: a "beep" is emitted. A continuous
measurement is started.
1x briefly: the continuous measurement is
stopped.
The last measured value is displayed in the primary
display.
Minimum-/Maximum-Measuring
This function enables determining the minimum or
maximum distance from a specific measuring point,
e.g. the determination of room diagonals (maximum
value) or horizontal distance (minimum value).
Switching on continuous measurement (see above).
The corresponding maximum and minimum values are
displayed.
