3
Quick Start
This chapter gives a brief summary of the steps required to set up and operate
the 2200 temperature controller. This should be used as a general overview and
reference and not as a substitute for the remainder of the manual. Please read
Sections 4 through 6 carefully before operating the controller.
3.1
Unpacking
Unpack the controller carefully and inspect it for any damage that may have oc-
curred during shipment. If there is shipping damage, notify the carrier
immediately.
An RTD control probe should have been purchased along with the controller.
Typically, the user provides the bath or system to be controlled and the heater.
Verify that the following components are present:
•
2200 Controller
•
Control Probe (if ordered)
•
Power Cord
•
Power Cord - for the Heater
•
Users Guide
3.2
Set Up
Set up of the controller requires unpacking and placement of the controller,
connection of the heater, installation of the control probe, and connection of
power.
CAUTION:
Consult Section 4 for detailed instructions for proper instal-
lation of the controller. Pay particular attention to instructions for the
heater, control probe, and power setup.
3.3
Setting the Temperature
In the following discussion and throughout this manual a solid box around the
word SET, UP, DOWN or EXIT indicates the panel button to press while the
dotted box indicates the display reading on the front panel. Explanation of the
button function or display reading is written at the right.
To view or set the temperature set-point proceed as follows. The front panel
LED display normally shows the actual process temperature.
24.68 C
Process temperature display
11
3 Quick Start
Unpacking