Maintenance and adjustment
7
end hub
PVA brush
Wheel tube
CHANGING BRUSHES (PVA)
a. Detach one of the side plates by removing the inside
screws, (see fig.7a, 7b).
b. With side plate detached, take out the wheel tube
from the machine.
c. Open the end hub and pull out the worn PVA brush.
d. Place the new PVA brush on to the hexagonal tube
and close it with the end hub.
e. Reinstall the wheel tube in place and place back the
side plate screwing back the screws.
PVA BRUSHES CARE:
This special brush material is most efficient when wet. Any discoloration is normal in the
drying process when exposed to open air. Please allow brushes to absorb pool water
for about 20 minutes before initial use or at first use of every season. You will notice that
as the brushes absorb the water and start scrubbing your pool, the discoloration will
disappear.
CHANGING BRUSHES (PVC)
a.
Remove the old brushes by removing the metal rod
(B)
b.
Wrap the new PVC brush (A) around the tube.
c.
Join the ends of the brush using the metal rod
d.
Slide the rod (B) through the tabs.
e.
Make sure that the rod is inserted through every
tab.
CHANGING BRUSHES
Depending upon how frequently you use the pool cleaner, it will be necessary to replace
the brushes when they are worn out. Worn out brushes will impede cleaner’s scrubbing,
climbing the walls or general performance.
6a
6b
7a
CHANGING THE DRIVE BELTS
Depending on usage, the drive belts (located behind the side plate) will stretch.
When this happens, in order to maintain the optimum performance of the unit, these drive
belts have to be changed.
a)
Turn the robot upside down and remove the bottom lid assembly (fig. 4a,4b,4c,4d).
b)
Inside, locate the screws on drive motor side, which hold the side plate in place (fig.
7a)
The number and location of screws may vary according to your model. Some of
the models have additional screws for which a flexible screwdriver is required (fig.
7b).
c)
Take out these screws and remove the side plate
d)
Remove the drive track. Before removing the drive track, notice carefully how the
drive belts are positioned for re-assembly (fig. 7c).
e)
Take out the old drive belts and replace them with new ones.
To re-assemble, reverse steps d to a.
7c
7b
Содержание AQUABOT SUPER BRAVO
Страница 1: ...BK 0009901 REV PA 2 37 30 23 16 9 ...
