/ 14 /
INSTALLATION OF FITTINGS AND TUBING
INSTALLATION OF FITTINGS AND TUBING
STEP 1
Screw in two (2) G1/4 threaded male fittings. Attach the liquid cooling tubes
and connect the water block(s) to the cooling loop.
Do not forget to plug the remaining two openings with enclosed
EK-Plug G1/4 or its equivalent.
EK recommends using EK fittings with all EK water blocks.
CAUTION: When using connectors other than EK fittings, pay spe-
cial attention to the length of the fittings male G1/4” thread - 5mm is
the maximum G1/4” thread length allowed!
TUBING
EK-ALU FITTING
G1/4 PLUG
STEP 1
STEP 1
Plug the 4-pin D-RGB connector from the GPU water block to the D-RGB
Header on your motherboard or controller. The LED strip will work only if the
pin layout on the header is as follows:
+5V, Data, Empty, Ground
.
Incorrect installation or installation to a wrong header can damage
the LED strip or the header itself!
D-RGB HEADER
RGB HEADER
STEP 1
