Step 3: Install Front Frame Assembly.
Set frame ends
into grooves of the tube-stops.
Fig-13
Make sure Stanchions
and Stanchion Hinges are facing towards the rear of the
boat. The frame may need to be flexed slightly to get into
the grooves. This is normal. Aligned Eye Ends with mounting
threaded hole and use supplied 1/4” button-head socket
screw to fasten.
Fig-14A
Tighten both fasteners. The front
frame should look like
Fig-14B
Step 4:
Install Rear Frame Assembly:
Make sure Quick-
Release Ball End Fittings are ready to accept frame Ball Ends.
Turn the D-Ring Twist Pin until groove is open.
Fig-13
With
Bimini Hinge Pins pointing upward on Rear Frame, insert one
end of Rear Frame ball fitting into the Quick-Release fitting
and slide downward to set in place. Do the same for the
opposite side. Lock in place by turning D-Ring Twist Pin until
groove is closed.
Fig-16
The rear bimini frame should look
like this.
Fig-17
Fluid Concepts Page 6
Fig 13
Fig 14A
Fig 14B
Fig 16
Fig 15
Fig 17
D-Ring Groove
Open
D-Ring Groove-
Closed
