Tools:
1. Hex keys x 3: 1/8” (or 3mm*), 5/32”, 1/4”
2. 9/16” wrench
2. Thread Lock (Loctite Blue) ---optional
*depending on components used in assembly
Bimini Frame Pre-Assembly:
Step 1:
Identify each frame piece according to
Fig-1.
Corner Fittings are identified by a colors (4 total)
Fig-3
.
Find corresponding tube piece with same color and insert
into Corner Fitting
Fig-4A
. Push until Snap Button clicks
into locating hole on Corner Fitting. Make sure pin is fully
engaged in hole as shown in
Fig-4B.
Repeat for the 3
remaining corners.
Note: Colors may not be the same as
shown in picures.
Step 2:
Tighten all set screws adjacent to Snap Button tube
locks.
Fig-5A
At this point you should have two separate
frames assembled (front frame and rear frame) as shown in
Fig-5B.
Fluid Concepts Page 3
Fig 3
Fig 4A
Fig 4B
Fig 5A
Fig 5B
Snap Button
Snap Button
fully engaged
Set Screw
Rear Frame
Front Frame
