Flowserve IPS Wireless SELD-102, Инструкция пользователя

Страница: 5 / 22

IPS WIRELESS SELD-102 Node ENGLISH 702-3001 07-17
Page 5 of 22
flowserve.com
+185°F)
Humidity: 0-95% noncondensing
Power requirement: 3.6 VDC Battery Pack
(Part Number S1-1061)
Base: 316LSS
Base Mounting: Magnetic base
, ½” NPT male. ¼
x 28 stud mount, flange mount or clamp mount
1.8.2 Built-In sensor specifications
RTD:
1000 Ohm (Platinum, 2 wire)
Pressure: Vacuum to 69 BAR (1000 psi) other
ranges available on request.
Vibration (Velocity): Single Axis or Tri Axis 0-25
mm/sec (0-1 ips)
Analog: 4-20 mA
Discrete: Dry Contact Only
2 TRANSPORT AND STORAGE
Make sure that hazardous substances are
disposed of safely and that the correct personal
protective equipment is used. The safety
specifications must be in accordance with the
current local regulations at all times.
2.1 Consignment receipt and unpacking
Immediately after receipt of the equipment it must
be checked against the delivery/shipping
documents for its completeness and that there has
been no damage in transportation. Any shortage
and/or damage must be reported immediately to
Flowserve and must be received in writing within
ten days of receipt of the equipment. Later claims
cannot be accepted.
Check any crate, boxes or wrappings for any
accessories or spare parts that may be packed
separately with the equipment or attached to side
walls of the box or equipment.
Each product has a unique serial number Check
that this number corresponds with that advised and
always quote this number in correspondence as
well as when ordering spare parts or further
accessories.
2.1.1 Unpacking
Carefully open package received from
factory and remove protective wrapping from
SELD-102 Node units and accessories. Inspect all
hardware for damage. Report any damage to
shipping carrier immediately.
Ensure you have received the correct sensors and
mounting accessories for your application. Cross-
check hardware received versus packing slip and
purchase order.
Record unit serial numbers for future reference.
2.1.2 Electrostatic Discharge (ESD) Handling
Procedure
The SELD-102 Node contains sensitive
electronic components that may be damaged by
static electricity present in work environments. The
following precautions are recommended to reduce
the risk of damage due to electrostatic discharge:

Only wipe exterior of unit with a damp cloth
Use of a grounding wrist strap when removing
outer plastic cover is recommended
2.2 Handling
Boxes, crates, pallets or cartons may be unloaded
using fork lift vehicles or slings dependent on their
size and construction.
2.3 Storage
Store the equipment in a clean, dry
location. The SELD-102 Node unit should be
powered-down prior to storage (see section 4
MAINTENANCE for how to power down unit) to
preserve battery life.
2.3.1 Storage and packaging
All SELD-102 Node units must be carefully
packaged for transport. Each unit should be boxed
individually with protective packaging (foam, bubble
wrap, etc.) in the box surrounding the SELD-102
Node.
After unpacking, protection will be the responsibility
of the user.
2.4 Recycling and end of product life
At the end of the service life of the product or its
parts, the relevant materials and parts should be
recycled or disposed of using an environmentally
acceptable method and in accordance with local
regulations. If the product contains substances that
are harmful to the environment, these should be