DataLoop™ LI25 Level Controller
Instruction Manual
MN301034 rev D
17
Pressing the
Right
or
Up
arrow moves the decimal point one place to the right
until no decimal point is displayed, then it moves to the left most position.
Setting the Units Display
(
units
)
The meter can be set to display a combination of three alphanumeric characters
for engineering units or for identification (eg. FT, IN, M, CM, GAL, L). There is
also a fourth alphanumeric character located above this row, which supports a
degrees symbol and “
x10
” symbol (eg.
°
C,
°
F,
x10
3,
x10
6,
x10
9).
Preconfigured units are available for feet (FT), inches (IN), meters (M),
centimeters (CM), gallons (GAL), liters (L), percent (%), and
percent (PCT).
A custom unit or tag may be entered as well, by selecting cust.
Press the
Up
arrow to scroll through unit options. Press
Enter/Ack
to select a
preconfigured unit or the custom unit or tag.
Entering a Custom Unit or Tag
Select
Custom
(cust) from the
Units
menu by pressing the
Enter/Ack
button. The
cursor will then show up in the left-most digit of the bottom three alphanumeric
tag characters.
Press
Right
arrow to select the next digit, and the
Up
arrow to cycle through the
alphanumeric characters available.
